## Millersville University will open at 10 a.m. 3/22

Due to Winter Storm Toby and the heavy snowfall, Millersville University will open at 10 a.m. on March 22. The grounds crew has been working hard to clear roads, parking lots and sidewalks, but needs some extra time in the morning to make sure walkways are clear.

Policy on Snow Delays/Cancellations

# Origin of Bending equation

The fundamental equation used to analyze beams is where y is the displacement shown in the figure, and x is the displacement in the figure, measured from the orange clamp at the bottom. M is the bending moment (torque) experienced by the beam at the location x. E is the Young's modulus, and I is called the "moment of area," or (incorrectly, but commonly enough that everyone understands) the "moment of inertia."

where the integral is over the cross sectional area of the beam. (If dA were an element of mass this would be a moment of inertia.)

To glimpse the origin of this formula, imagine a rectangular beam bent (gently) into a circle of radius R. In the figure, c is the distance from the beam center (strictly the centroid) to the outer edge of the beam. A point on the outer edge is marked with a dot, a distance R+c from the center.

In xy coordinates, starting at the origin, a point which lies a distance S from the origin, has risen a distance y above its original horizontal position. The location, x, of this point is shown. It is approximately true that x=S. We will take the limit of small x to improve this approximation.

For small x, the angle theta can be related to the derivative of y with respect to x for the outer edge of the beam.

We eliminate R from this expression by considering the strain induced in the outer edge of the beam when it is flexed into this curved shape. In bending, the inner edge of the beam is compressed, the outer edge is stretched, and the centroid is unchanged in length. The strain in the outer edge is:

so that:

This in turn is related to Young's modulus, E, and the tensile stress s in the outer edge:

Using the result thatat the outer edge, we have

Now enforce the requirement that s be small. In that case, s is the same as x, and in particular

Taking the derivative of both sides of the dy/dx equation, we can eliminate s by forcing it to be small in the limit for the derivative: